lay your two pieces of fabric right sides jointly. place the coat hanger on the part of the fabric so that the hock is approximately 1.5cm in from the edge. draw around half the hanger.leaving a border 1.5cm .
Cut OUT these shapes.then repeat on the lower part of the fabric : you should have four
shapes altogether .
SPRAY THE hanger with fabric adhesive then wrap the strips of wadding around it. put an
extra square of wadding over the ends of the
hanger in next step....
PLACE THE cut-out pieces right sides together.pin them.then sew all the way round .leaving the short straight end open turn the right way out and press.you will have two matching "sleeves".slip the fabric sleeves over each side of the hanger .
FOLD IN the fabric at the join .then and stitch the two sleeves together .dont worry too much about stitching neatly as this will be covered ribbon.
Glue a piece of decorative ribbon over your stitches .and finish off with a little bow . if you like .pop a little fabric adhesive on to the hook and wrap ribbon around it to finish .
0 comments:
Post a Comment